Running Tools

‘A’ shank is used with the ‘C1’ running tool to run lock mandrels into the well (keeping dogs retracted during running in). It can also be used as a probe carrier when probes are required during running in operations.

The model ‘WC-C1’ running tool runs flow Control devices into the well those have external fishing neck locks. A thread protector, which has the same OD as the tool body, makes selective setting possible. A seal bore locating ring provides Top No go setting. The ‘C1’ running tool has box-down connection to make up with ‘A’ or ‘N1’ type shanks as required.

‘N1’ shank is used in conjunction with the ‘C1’ running tool to run and land flow control equipments such as lock mandrels, blanking plugs, etc into landing nipples.

The ‘X Line’ Selective Running Tool is designed to install subsurface control equipments using a type WC-LM-X Locking Mandrel. The selective features of the WC-X Line Running Tool allow the operator to install the down-hole device in a pre-determined WC-LNP-X Landing Nipple by adjusting the tool into the selective position. If the subsurface control is to be installed in the upper most landing nipple, the locking mandrel may be run with the keys in the control or location position. In addition to setting the WC-LM-X Locking Mandrel, the Running Tool may be used to locate WC-LNP-X Landing Nipples. The ‘R Line’ Selective Running Tool, similar in design, is also available in a wide range of sizes to install Type WC-LM-R Locking Mandrels in heavy weight tubing.